Hammer Bits

The depths With the use of a hammer, Hammer Bits, also known as DTH Hammer Bits, crush hard rock into tiny dust and cuts. By using air, water, or drilling mud, this is removed. It is one of the easiest ways to break through rocks like welded tuff, basalt, or grit.

High penetration rates, good rock breakup, and high productivity are all benefits of pneumatic energy transmission because to its minimal energy loss. A straight, clean borehole is produced by the hammer in an exact location. In these hard rock conditions, DTH Hammer Bits is a lot faster than drilling methods.

With a diameter ranging from 450mm to 1000mm and a depth of 26m, LEANOMS's DTH Hammer Bits generate a high-quality hole.

Our Casing System enables LEANOMS to hammer the pile while simultaneously installing a casing at the specified depth. As the hole is being created, its progressive enclosure regulates the collapse of loose materials.

Hammer DHD340 DTH transmits high impact energy with less energy loss. Good rock breakage, high penetration rates, and high productivity are the outcomes of this. The machinery is built to produce holes with the highest possible hole quality, dependability, and service life, as well as the best blasting outcomes and lowest possible total operating costs. In a nutshell, the DHD DTH hammer is by far the quickest when drilling into rock!

When thick layers of material 20Mpa or more are found, the DTH technique offers an alternative to traditional rock coring. These layers are often generated by basalt deposits, grit, or welded tuff. The DTH approach is, whenever possible, much faster than coring methods. In contrast to the 1-2 m/day that could be achieved if the piles were cored, we can often obtain 20-30 lm/day utilizing our DTH rig.

SpecificationLEANOMS